Guide

How often should restaurants jet their grease lines?

Grease lines clog on a schedule of their own. Here is how restaurant owners and managers can stay ahead of backups.

Published November 17, 2026 by Sewer-Jetting.com

For a restaurant, a grease line backup is more than a plumbing problem. Floor drains overflow, sinks stop draining, and the kitchen may have to stop service. The good news is that grease lines are predictable. They clog because grease builds up a little at a time, which means a maintenance schedule can prevent most backups. This guide explains how grease lines clog, how jetting helps, and how to figure out how often your kitchen needs it.

How a grease line clogs

Fats, oils, and grease (often called FOG) go down kitchen drains as warm liquid. As they cool in the pipe, they stick to the walls and harden. Food particles, starches, and soap residue stick to the grease, and the layer grows. Over time the opening in the pipe shrinks until the line drains slowly, then stops.

The lines most affected are the ones between the kitchen fixtures and the grease trap or interceptor, plus floor drains, and the line downstream of the trap if grease gets past it.

Why snaking a grease line does not last

A cable machine can open a grease clog quickly by boring through the middle. But grease is soft and sticky, and most of it stays on the pipe wall. The line works for a while, then the opening closes again. Many restaurants get stuck in a cycle of emergency calls for the same line.

Hydro jetting breaks that cycle. High-pressure water from a nozzle scours the full circumference of the pipe, cutting the grease off the walls and flushing it out. The line is cleaned back toward its full diameter instead of just reopened. For a full comparison, see hydro jetting vs. snaking.

Jetting the line vs. pumping the grease trap

These are two different jobs, and a kitchen needs both:

  • Pumping the grease trap or interceptor removes the grease and solids that the trap has captured. Many utilities set rules for how often traps must be pumped, often tied to how full the trap gets. A widely used guideline is to pump before grease and solids reach about one-quarter of the trap's depth. Check the requirements of your local utility.
  • Jetting the lines cleans the pipes that feed into the trap and lead out of it, along with floor drains. A trap that is pumped on schedule does not clean the grease coating inside the kitchen lines.

So how often should a restaurant jet its grease lines?

There is no single number that fits every kitchen. The right interval depends on:

  • Menu and cooking style. Fryers, grills, and heavy sauce cooking send more grease down the drain than a cafe or bakery.
  • Volume. A kitchen doing many covers a day builds up grease faster.
  • Kitchen practices. Scraping plates, using sink strainers, and keeping grease out of drains all slow buildup.
  • Pipe layout and condition. Long runs, low spots, and older cast iron catch more grease.
  • History. A line that has backed up before will usually do it again on a similar timeline.

Many restaurants put grease lines on a recurring schedule, commonly somewhere between every few months and twice a year, and adjust from there. The best way to set the interval is to camera the line after a cleaning and again at the next visit. If the camera shows heavy buildup, shorten the interval. If the line is still clean, it can be stretched. The goal is to clean the line before it backs up, not after.

Signs a grease line needs jetting now

  • Floor drains slow to empty or backing up during busy service
  • Sinks draining slowly
  • Sewer or grease odors in the kitchen
  • Gurgling from drains
  • Calls for the same line more than once in a few months

Planning maintenance around service

The worst time for a grease line to back up is during a busy dinner. Scheduled jetting lets you choose the time. Commercial jetting visits can often be planned before opening, after closing, or on a slow day, depending on the site. When you call, tell us:

  • Your hours and the best window for work
  • Where cleanouts, floor drains, and the grease trap are
  • Which fixtures back up and how often
  • Whether the landlord or property manager needs to be involved

Keep grease out of the line between cleanings

  • Scrape plates and pans into the trash before washing
  • Collect used fryer oil in a container for recycling, never down the drain
  • Use strainers in sinks and floor drains
  • Train staff on what not to put down drains
  • Keep the grease trap pumped on its schedule

Grease line jetting in South Florida

South Florida's dining districts, from Las Olas Boulevard in Fort Lauderdale to Atlantic Avenue in Delray Beach, Mizner Park in Boca Raton, and Clematis Street in West Palm Beach, put heavy demand on commercial kitchen lines. We provide commercial hydro jetting, grease line jetting, floor drain cleaning, and camera inspection for restaurants in Fort Lauderdale, Delray Beach, Boca Raton, West Palm Beach, and across South Florida, and can set up a maintenance program. Call (954) 914-5151 for a free estimate.

FAQ

Frequently asked questions

How often should a restaurant grease line be jetted?

It depends on the menu, volume, kitchen practices, and the pipe. Many restaurants schedule jetting every few months to twice a year and adjust the interval from camera findings.

Is pumping the grease trap enough?

No. Pumping removes what the trap has captured, but it does not clean the grease coating inside the kitchen lines and floor drains. Those lines need to be jetted.

Can grease line jetting be done outside business hours?

Commercial visits can often be scheduled before opening, after closing, or on a slow day, depending on the site.

Need Drain Cleaning Today?

We're Ready to Help!

(954) 914-5151

All calls answered by the owner-operator.

Call (954) 914-5151